JIS K7170-2008 塑料.设计数据的采集和表示指南

上一篇: JIS K6952-2008 塑料.在半工业性实验规模规定的合成条件下塑料材料降解程度的测定
下一篇: JIS K6870-2008 胶粘剂.多成分胶粘剂使用寿命(适用期)的测定

Product Code:SAE MAM5822
Title:Steel, Corrosion and Heat Resistant, Welding Wire 11.8cr 2.8ni 1.6co 1.8mo 0.32v Vacuum Induction Melted (Cancelled Jul 2003)
Issuing Committee:Ams F Corrosion Heat Resistant Alloys Committee
Scope:This specification covers a corrosion and heat resistant steel in the form of welding wire.Product Code:SAE J2236
Title:Standard Method for Determining Continuous Upper Temperature Resistance of Elastomers
Issuing Committee:Committee On Automotive Rubber Specs
Scope:This method is intended to define the continuous upper temperature resistance (CUTR) of thermoplastic elastomers and thermoset rubber with durometer hardness less than or equal to 90 Shore A, to oxidation or other degradation when exposed solely to hot air for an extended period of time.This method established the upper thermal aging limits of commercially available compounds as measured at 23 掳C by retention of at least 50% original elongation and tensile at break after 1008 h of heat aging. This method does not take into account nor measure the effects of stress, environment, or temperature variations on the thermal aging characteristics of the materials tested.This method may involve hazardous materials, operations, and equipment. This SAE Standard does not address the safety problems associated with its use. It is the responsibility of the user of this document to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.This test method is based on SI units.